|
|
|
|
|
|
The
ACSS 
TSCM
Marketplace
Listing Detail
ACECO SC-1 Radio
Frequency Counter
Pre-Owned ACECO SC-1 Radio Frequency Counter Absolutely Like New!
$139 + $9.50 Shipping & Insurance
Seller: Norbert Zaenglein 317 E. Thurber Clay Center, NE 68933 (402) 762-5110
Unit Comes with antenna, charger and instructions. as shown in the following photo.
|
ACECO SC-1 Condition: Pre-Owned - Used Twice Tested: Fully Operational Appearance: New Warranty: Fully Tested But Sold As Is Instructions: Printed Instructions Included Cost: $139 + $9.50 Shipping & Insurance Restrictions: Will Ship To U.S. Only ACECO SC-1 The Aceco SC-1 hand-held radio frequency counter is compact, truly pocket-sized, versatile test instrument designed for measuring any digital, on/off keying or analog signal on frequencies between 30 MHz and 2.8 GHz. Supplied as a complete with internal NiCd pack, AC wall charger and 7 section telescopic antenna.
Specifications
Features * 7 digit Liquid Crystal Display * Frequency counter for digital, on/off keying and analog signals with a minimum pulse width of 250 uS. * Ultra sensitive synchronous detector - 16 section bargraph to show RF signal strength (-35dBm to 0dBm) * Two range positions - the 1 GHz position for frequencies between 30 MHz and 0.8 GHz and the 2.8 GHz position for frequencies between 500 MHz and 2.8 GHz. * Squelch adjustment for input signals * Hold switch to lock display * Low battery indicator * Low power consumption (Average 5 hour battery life) Controls 1. SQL Knob - This knob turns the RF counter on and tunes the squelch up or down to set the signal strength for reception. 2. Range Switch - This should be switched to the 1 GHz position for frequencies between 30 MHz and 0.8 GHz and switched to the 2.8 GHz position for frequencies between 500 MHz and 2.8 GHz. 3. Hold Button - This holds the current display and stops the counter from counting. 4. Calibration - The calibration adjustment opening is located on the front panel of the counter. This allows access to the trimmer capacitor that provides about a 10 PPM adjustment range of the time base oscillator. This is not usually necessary but to do so read a signal of a known frequency before adjusting the trimmer for correct frequency display. If you calibrate at 4.1943 MHz or above then the counter will be more accurate.
Disclosure & Disclaimer Information on the ACSS marketplace is listed without any warranties whatsoever. Buyer alone is responsible to ensure that products listed herein are as described. Buyer agrees to hold harmless ACSS, its Board of Directors and its management from any and all claims that may arise from use of the listing information and/or from the purchase of any products listed on this site. Buyers and sellers alone are responsible for determining the status regarding the legal transfer of TSCM equipment and instrumentation within and outside the United States. |
Disclaimer
The information in this website is provided without any warranties for accuracy or completeness and visitors are encouraged to seek professional and/or legal advice concerning specific threats or countermeasure. No one affiliated with this web site assumes any legal liability or responsibility whatsoever, for the accuracy, completeness or usefulness of any of the information contained on this web site or its links, its to any other site references or the accuracy or completeness of information from any site references and links. The information provided in the Member Magnifier pages has been furnished by the individual business and ACSS cannot verify the accuracy or completeness of this information. It is up to the visitor to verify any and all information contained herein. Ownership of all trademarks, etc. referred to on this site is acknowledged.
Thank You For Visiting
